LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 288 (Drive Shaft) >> Drive Shaft (FS MTX Left Side And FS With TC Left Side) Disassembly/Assembly >> Cage, Inner Ring, Balls, Snap Ring Assembly Note

Cage, Inner Ring, Balls, Snap Ring Assembly Note

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the marks and install the balls and cage to the inner ring in the direction shown in the figure.
    CAUTION:
    • Install the cage with the offset facing the snap ring groove. If incorrectly installed, the drive shaft may become disengaged.
  2. Install a new snap ring.
    Fig 1: Installing Cage, Inner Ring, Balls, Snap Ring Assembly
    G01914027Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals