LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 115 (Rear Suspension) >> Rear Suspension >> Rear Stabilizer >> Rear Stabilizer Removal/Installation >> Stabilizer Bushing and Bracket Installation Note

Stabilizer Bushing and Bracket Installation Note

WARNING: This page is about a different car, the 2003 Mazda Protege5, 2003 Mazda Protege, 2002 Mazda Protege5, and 2002 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the bushing with the positioning bushing on the stabilizer bar.
  2. Temporarily install the stabilizer bracket so that the slot (or elongated hole) faces downward.
    Fig 1: Positioning Stabilizer Bushing & Bracket
    G00379538Courtesy of MAZDA MOTORS CORP.
  3. Tighten the stabilizer bracket nut, then bolt.
scientia non olet · About LEMON Manuals