Vehicle Cold Soak Procedure

To carry out this procedure, proceed as follows:

• Test preparations include matching customer conditions (if known). If not known, document the test conditions: gear selection and engine RPM. Monitor the vibration/noise duration with a watch for up to three minutes.
• Park the vehicle where testing will occur. The vehicle must remain at or below the concern temperature (if known) for 6-8 hours.
• Before starting the engine, conduct a visual inspection under the hood.
• Turn the key on, but do not start the engine. Listen for the fuel pump, anti-lock brake system (ABS) and air suspension system noises.
• Start the engine.
  CAUTION:

  • Never probe moving parts.
• Isolate the vibration/noise by carefully listening. Move around the vehicle while listening to find the general location of the vibration/noise. Then, search for a more precise location by using a stethoscope or EngineEAR PROBE.
• Refer to SYMPTOM TROUBLESHOOTING CHART - IDLE NOISE/VIBRATION  to assist with the diagnosis.