LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> B2300 Base, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - Overhaul - (LF, L3) >> Cylinder Head (II) Assembly >> Camshaft Assembly Note

Camshaft Assembly Note

  1. Set the cam position of No.1 cylinder at the Top Dead Center (TDC) and install the camshaft.
  2. Temporarily tighten the camshaft bearing caps evenly in 2-3 passes.
  3. Tighten the camshaft cap bolt in the order shown two steps.

    Tightening Torque 

    1. (1) 5.0-8.0 N.m {51.0-81.5 kgf.cm, 44.3-70.8 in.lbf} 
    2. (2) 14-17 N.m {1.43-1.73 kgf.m, 10.4-12.5 ft.lbf} 
        Fig 1: Camshaft Cap Bolt Tightening Sequence
        G02831659Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals