LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> B2300 Base, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Controls [Removal & Installation] >> Engine Sensors & Switches >> Knock Sensor >> Removal & Installation (Mazda6 3.0L)

Removal & Installation (Mazda6 3.0L)

  1. Disconnect the negative battery cable.
  2. Disconnect the knock sensor harness connector. See Figure.
  3. Remove the knock sensor.
  4. To install, reverse removal procedure. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals