LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> B2300 Base, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Controls [Removal & Installation] >> Engine Sensors & Switches >> Heated Oxygen Sensor >> Removing & Installing (Tribute 3.0L)

Removing & Installing (Tribute 3.0L)

  1. Raise and support the vehicle.
  2. Disconnect the Heated Oxygen Sensor (HO2S) harness connector. See Fig 1 and/or Fig 2.
    3. NOTE: If necessary, lubricate the HO2S with penetrating and lock lubricant to aid in removal.
  3. Using the Special Tool (303-476), remove the HO2S. See Fig 3 and/or Fig 4.
Fig 1: Locating HO2S Harness Connector (Left Side) - Tribute (3.0L)
G00264403Courtesy of MAZDA MOTORS CORP.
Fig 2: Locating HO2S Harness Connector (Right Side) - Tribute (3.0L)
G00264404Courtesy of MAZDA MOTORS CORP.
Fig 3: Removing & Installing HO2S (Left Side) - Tribute (3.0L)
G00264406Courtesy of MAZDA MOTORS CORP.
Fig 4: Removing & Installing HO2S (Right Side) - Tribute (3.0L)
G00264405Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals