LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> B2300 Base, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Controls [Removal & Installation] >> Engine Sensors & Switches >> Camshaft Position Sensor >> Removal & Installation (B3000)

Removal & Installation (B3000)

  1. Disconnect negative battery cable.
  2. Remove the upper intake manifold. See UPPER INTAKE MANIFOLD  under AIR INDUCTION SYSTEMS.
  3. Disconnect Camshaft Position (CMP) sensor harness connector. See Fig 1.
  4. Remove the screws and the CMP sensor. See Fig 2.
  5. To install, reverse removal procedure. See TORQUE SPECIFICATIONS .
Fig 1: Locating CMP Sensor Harness Connector - B3000
G00252954Courtesy of MAZDA MOTORS CORP.
Fig 2: Removing & Installing CMP Sensor - B3000
G00252955Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals