LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> B2300 Base, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Controls [Removal & Installation] >> Engine Sensors & Switches >> Camshaft Position Sensor >> Removal & Installation (B2300)

Removal & Installation (B2300)

  1. Disconnect the negative battery cable.
  2. Disconnect the Camshaft Position (CMP) sensor harness connector.
  3. Remove the bolt and the CMP sensor. See Fig 1.
  4. To install, reverse removal procedure. Lubricate the "O" ring with clean engine oil. See TORQUE SPECIFICATIONS .
Fig 1: Removing & Installing CMP Sensor - B2300
G00252898Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals