LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> Steering >> Power Steering >> Power Rack & Pinion >> Adjustments >> Pinion Preload >> Protege

Pinion Preload: Protege

  1. Ensure steering rack is in center position. Using Protractor (49-D032-316) and torque wrench, tighten adjusting cover to 14 ft. lbs. (20 N.m), then loosen adjusting cover 23 degrees. See Figure.
  2. Attach Install Preload Adapter (49-0180-510B) on pinion shaft. See Figure. Measure pinion preload using spring scale. Pinion preload should be 2.0-3.0 lbs. (.9-1.3 kg). Apply sealant to threads of lock nut. Install lock nut.
  3. If preload is not as specified, repeat procedure. If preload is as specified, apply thread sealant to adjusting cover lock nut. Install lock nut. Hold adjusting cover in place and tighten lock nut to 29-36 ft. lbs. (40-49 N.m).
scientia non olet · About LEMON Manuals