LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag System >> Disposal Procedures >> Off-Vehicle Deployment (Seats Installed) >> Side AIR Bag (Seats Installed)

Side AIR Bag (Seats Installed)

  1. Before deploying air bag, inspect operating condition of Deployment Tool (49 H066 002). See INSPECTING DEPLOYMENT TOOL  . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove appropriate side air bag module. See SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Install nuts onto studs located on side of air bag module. Position air bag module inside of scrap tire with trim pad facing center of tire. See Figure . Using strong wire, attach air bag module to tire, wrapping wire around tire and air bag module nuts least 4 times.
  3. Stack 2 scrap tires under tire which air bag is attached. Connect deployment tool to air bag connector. Place another tire and then a scrap rim and tire assembly on top of entire stack and tie stack together with strong rope. Connect Red clip of deployment tool to positive battery terminal and Black clip of deployment tool to negative battery terminal. Verify deployment tool Red light is on.
  4. Ensure all persons are at least 20 feet from air bag module. Press deployment tool activation switch to deploy air bag. Because of heat generated from air bag deployment, wait at least 15 minutes before handling deployed air bag module. Place deployed air bag module in plastic bag, seal bag and disposed of like any other part.
scientia non olet · About LEMON Manuals