General Disabling Procedure (Seats Installed)
WARNING:
Unintentional air bag module deployment is possible. Personal injury may result. The following general deactivation procedure should not be used when performing air bag diagnostics or repairs. See COMPONENT REPLACEMENT DISABLING PROCEDURE
or DIAGNOSTICS ACTIVATING PROCEDURE
.
This procedure should only be used when performing repairs not related to air bag system, including seat systems (lumbar, climate control, heated seat, power seat track, etc.).
- Record pre-set radio frequencies for reprogramming (if equipped). Move and tilt front seats highest and most forward position. Disconnect negative battery cable. Wait at least one minute for back-up power supply to deplete stored energy.
- Remove steering wheel access cover. Disconnect driver-side air bag module connector. Install Air Bag Simulator (418-F468) to clockspring side of clockspring electrical connector, located at top of steering column (in place of air bag). See AIR BAG SIMULATOR .
- Open glove box past its stops. Through glove box opening, disconnect passenger-side air bag module connector. Connect Air Bag Simulator (418-F468) to passenger-side air bag vehicle harness connector (in place of air bag).
- Remove left seat belt buckle pretensioner electrical connector from bracket under seat. Disconnect pretensioner electrical connector. Install Air Bag Simulator (418-F468) to harness side of pretensioner electrical connector. Repeat procedure for right side pretensioner.
- On models equipped with side air bags, reach under left front seat and disconnect left side air bag module electrical connector. Install Air Bag Simulator (418-F470) to harness side of left side air bag electrical connector. Repeat procedure for right side air bag module. On all models, reconnect negative battery cable.