Activating Air Bag System (CR-V, Insight, Odyssey & S2000)

Ensure ignition is OFF and both battery cables are disconnected. Wait at least 3 MINUTES. Connect driver air bag connector. Install access panel.
Connect passenger air bag connector. Install glove box or access panel. Connect both front seat belt pretensioner 2-pin connectors to SRS main harness. Install trim panels. On CR-V and Odyssey, connect both side air bag module connectors. On CR-V, connect both front seat belt buckle tensioner connectors.
Reconnect battery cables. Check SRS indicator light to ensure system is functioning properly. See SYSTEM OPERATION CHECK . Reprogram radio frequencies.

Fig 1: Disabling Passenger Air Bag (S2000 Shown; Insight Is Similar)

Fig 2: Disabling Seat Belt Pretensioner (S2000)