Mode 06 (EVAP System Repair Verification Drive Mode)

NOTE: If "EVAP System Repair Verification Drive Mode" cannot be performed (it is impossible to drive the vehicle under this drive mode condition), perform the EVAP system test procedure as an alternative.

Start the engine and warm it up completely.
Verify that all of the following PIDs are within the following specifications. All PIDs must be within specifications before the engine is started to initiate the EVAP system test.
- BARO:above 72.2 kPa {542 mmHg, 21.3 inHg}
- IAT:5-35°C {41-95°F}
- FTL:15-85%
- B+:above 10.9 V
Clear the DTC from the PCM memory using the M-MDS.
Turn the ignition switch off.
Leave the vehicle for3.5 h or more.
Start the engine and idle it formore than 5 min.
Drive the vehicle with D range at an engine speed of68-77 km/h {42-48 mph} for more than 20 min.
Stop the vehicle and the turn ignition switch off.
Leave vehicle as it is for1 h or more.
Start the engine.
Access the ON BOARD SYSTEM READINESS to verify the OBD monitoring status.
- If completed, the OBD monitoring status items change from non-completed to completed.
- If not completed, turn the ignition switch off then go back to Step 1.
Access the DIAGNOSTIC MONITORING TEST RESULTS to verify the monitor results.
- If detected values are not within specification, the repair has not been completed.
Verify that no DTCs are present.