EVAP System Repair Verification Drive Mode (4 Cylinder W/O Turbo & V6)

NOTE: If "EVAP System Repair Verification Drive Mode" cannot be performed (it is impossible to drive the vehicle under this drive mode condition), perform EVAP system test procedure as an alternative.

Verify that all of the following PIDs are within the following specifications. All PIDs must be within specifications before engine is started to initiate the EVAP system test.
- BARO:more than 72.2 kPa {542 mmHg, 21.3 inHg}
- IAT:5-40 °C {41-104 °F} 4 Cylinder:5-35 °C {41-95 °F} V6
- FTL:15-85%
- B+:more than 10.9 V
Clear the DTC from the PCM memory using the WDS or equivalent.
Start the engine and idle it formore than 10 s , then turn ignition switch off.
Leave vehicle for5 hours or more .
Start the engine and idle formore than 15 min .
Drive the vehicle at an engine speed of65-80 km/h {40-50 mph} formore than 5 min .
Stop the vehicle and turn ignition switch off.
Leave vehicle as it is for10 min or more .
Start the engine.
Access the ON BOARD SYSTEM READINESS to verify the OBD monitoring status.
- If completed, the OBD monitoring status items change from non-completed to completed.
- If not completed, turn the ignition switch off then go back to Step 1.
Access the DIAGNOSTIC MONITORING TEST RESULTS to verify the monitor results.
- If detected values are not within specification, repair has not completed.
Verify no DTCs are available.