LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycles >> 1999: B2500, B3000, B4000 >> Monitor Repair Verification Drive Cycle >> Misfire Monitor Repair Verification Drive Cycle

Misfire Monitor Repair Verification Drive Cycle

NOTE:
  • FLI  PID must be above 15% (percentage fuel tank fill) to initiate the Misfire monitor.
  • If MIL illuminates anytime during this drive cycle, discontinue the test.
  1. Drive the vehicle to a location where speeds can reach 55 to 60 mph (88 to 97 km/h) and coast down to 40 mph (64 km/h) without traffic interference.
  2. Accelerate at wide-open throttle to allow vehicle to shift at near red-line (if equipped with a tachometer). Immediately return to normal speed limits.
  3. Perform the following drive procedurethree  consecutive times.
    1. Accelerate on highway to 60 mph (97 km/h) and maintain speed for more than 30 seconds.
    2. Coast down with foot off the accelerator pedal from 60 to 40 mph (97 to 64 km/h).
  4. Perform Continuous Memory, KOEO and KOER ON-DEMAND SELF-TESTS.
  5. Verify no DTCs are available.
scientia non olet · About LEMON Manuals