LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Mechanical - 2.0L) >> Mechanical - General Inspection >> Cylinder Bore - Out-Of-Round

Cylinder Bore - Out-Of-Round

WARNING: This page is about a different variant/trim than selected.
  1. Measure the cylinder bore in two directions. The difference is the out-of-round. Refer to SPECIFICATIONS . Verify the out-of-round is within the wear limit and bore the cylinder to the next oversize limit.
    Fig 1: Measuring Cylinder Bore Out-Of-Round
    G01898670Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals