LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Servicing - M/T) >> Removal & Installation >> Vehicle Speed Sensor >> Removal & Installation (2WD)

Removal & Installation (2WD)

WARNING: This page is about a different variant/trim than selected.

Disconnect Vehicle Speed Sensor (VSS) harness connector. See Figure . Remove retaining bolt and VSS. See Figure . To install, reverse removal procedure. Tighten bolt to specification. See TORQUE SPECIFICATIONS  .

scientia non olet · About LEMON Manuals