LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Servicing - M/T) >> Adjustments >> Gearshift Cable

Gearshift Cable

WARNING: This page is about a different variant/trim than selected.
NOTE: Make sure that the gearshift lever is in neutral and the parking brake is set.
  1. If necessary, remove the center console trim and gearshift lever boot. Remove the gearshift lever knob. Remove the center console trim and gearshift lever boot. Release the gearshift cable adjuster lock. See Fig 1 .
    2. NOTE: The transaxle is in neutral when the angle between the gearshift lever and the transaxle shift lever is 90 degrees. See Fig 2 .
  2. Release the gearshift cable adjuster. See Fig 3 . Set the transaxle in neutral. Push in the adjuster and secure the lock. If necessary, install the center console trim, the gearshift lever boot assembly and the gearshift lever knob.
Fig 1: Identifying Gearshift Cable Adjuster Lock
G00120894Courtesy of FORD MOTOR CO.
Fig 2: View Of Transaxle Shift Lever In Neutral
G00120896Courtesy of FORD MOTOR CO.
Fig 3: Identifying Gearshift Cable Adjuster
G00120895Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals