DTC 22: Cruise Control Switch (Resume/ACCEL Switch)
WARNING: This page is about a different car, the 2002 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
Access cruise control module, located behind right kick panel. Disconnect cruise control module harness connector. Measure resistance between ground and terminal "L" (Violet wire) at cruise control module harness connector while depressing RESUME/ACCEL switch. See Figure . If resistance is 68 ohms, system is okay. If resistance is other than 68 ohms, replace cruise control module. Retest system operation.