LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Power Door Locks & Keyless Entry) >> Removal & Installation >> Sliding Door Trim

Sliding Door Trim

WARNING: This page is about a different car, the 2002 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable if equipped with power window.
  2. Remove the sliding door garnish.
  3. Remove the sliding door upper frame.
  4. Remove the sliding door inner handle.
  5. Remove the regulator handle if equipped.
  6. Disengage clips A using a fastener remover.
  7. Pull the sliding door trim upward, then disengage hook B from the body.
  8. Disconnect the power window sub switch connector if equipped.
  9. Remove the sliding door trim.
  10. Install in the reverse order of removal.
Fig 1: Removing Sliding Door Trim
G01196566Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals