LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Power Door Locks & Keyless Entry) >> Removal & Installation >> Pcm >> PCM Panel Removal Note

PCM Panel Removal Note

WARNING: This page is about a different car, the 2002 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before removing the PCM panel, pull the PCM connector harness stay fastener out from the PCM panel.
  2. Remove the upper right side of the PCM panel installation nut located at the back of the blower unit as shown.
    Fig 1: Removing PCM Panel Installation Nut
    G01197095Courtesy of MAZDA MOTORS CORP.
  3. Remove the lower side of the PCM panel installation nuts located at the bottom of the cabin carpet.
  4. Remove four installation nuts, then pull the PCM panel down to remove from installation place.
Fig 2: Removing PCM From Installation Place
G01197096Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals