Rear Tilt Motor
WARNING: This page is about a different car, the 2002 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
Remove the front seat. See FRONT SEAT in REMOVAL & INSTALLATION. Disconnect the rear tilt motor connector, and check operation of the seat when battery positive voltage is applied to the terminals as shown. See Fig 1 and REAR TILT MOTOR TEST table. If not as specified, replace the rear tilt motor.
REAR TILT MOTOR TEST
| Connect Battery Voltage | Connect Ground | Seat Operation |
|---|---|---|
| A | B | Up |
| B | A | Down |