Test No. 10: Brake System Warning Light Does Not Illuminate With Parking Brake Set
WARNING: This page is about a different car, the 2002 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
- Remove driver's front scuff plate. Remove driver's kick panel. Remove CPU from joint box. Connect ground to joint box terminal 1D. See Fig 1 . Turn ignition to ON position. If BRAKE light illuminates, go to next step. If BRAKE light does not illuminate, go to step 4 .
- Remove rear console. Disconnect parking brake switch connector. Engage parking brake. Check for continuity between ground and parking brake switch terminal. If continuity exists, go to next step. If continuity does not exist, replace parking brake switch.
- Connect ground to parking brake switch terminal. Check for continuity between ground and joint box terminal 1P. If continuity exists, replace CPU. If continuity does not exist, repair wiring between CPU and parking brake switch. See WIRING DIAGRAMS .
- Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. Check for continuity between ground and instrument cluster harness connector No. 3, terminal 3L. See Figure . If continuity exists, go to next step. If continuity does not exist, repair wiring between instrument cluster and CPU.
- Remove BRAKE system warning light bulb. Inspect bulb. If bulb is bad, replace bulb. If bulb is okay, replace instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION.