Purge Control Solenoid Valve
WARNING: This page is about a different car, the 1997 Mazda Millenia. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect purge control solenoid valve connector. See the PURGE CONTROL SOLENOID VALVE LOCATIONS table. Ensure air does not flow through solenoid valve vacuum ports. Using jumper wires, apply battery voltage to solenoid valve terminals. Apply air pressure to a solenoid valve port. Air should flow from other port. If valve does not operate as specified, replace solenoid valve.
PURGE CONTROL SOLENOID VALVE LOCATIONS
| Application | Location |
|---|---|
| Millenia 2.3L | Top Right Of Engine |