Vehicle Preparation

WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.

Connect scan tool to vehicle. Verify the following PIDs:

IAT PID 40-100°F (4-38°C)
FLI PID 50-75 percent.
ECT PID minimum of 170°F (77°C)

Without returning to key off, using scan tool, clear all DTCs. DTC P1000 will remain. Using scan tool, view status of OBD-II monitors. Proceed to OBD-II DRIVE CYCLE PROCEDURE if necessary or proceed to identified monitor drive cycle. See MONITOR REPAIR VERIFICATION DRIVE CYCLES .