LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Engine Controls [Removal & Installation]) >> Fuel System >> Fuel Rails & Injectors >> Removal & Installation (Mazda6 3.0L & MPV)

Removal & Installation (Mazda6 3.0L & MPV)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2003 Mazda Tribute, 2003 Mazda Protege5, 2003 Mazda Protege, 2003 Mazda MX-5 Miata, and 2003 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Relieve system pressure. See FUEL SYSTEM PRESSURE RELEASE .
  2. Disconnect the negative battery cable.
  3. Remove the dynamic chamber. See INTAKE AIR SYSTEM  under AIR INDUCTION SYSTEMS.
  4. Disconnect the fuel injector harness connectors and remove the harness from the fuel distributor.
    5. CAUTION: Disconnecting/connecting the quick release connector without cleaning it may possibly cause damage to the fuel pipe and quick release connector. DISCONNECT  under FUEL LINE CONNECTORS (MAZDA6, MPV, PROTEGE & PROTEGE5). Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it is free of foreign material.
  5. Remove in the order indicated in the illustration. See Fig 1.
  6. To install, reverse removal procedure. See TORQUE SPECIFICATIONS .
Fig 1: Removing & Installing Fuel Rail & Injectors - Mazda6 (3.0L)
G00256272Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals