Removal & Installation (B4000)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2003 Mazda Tribute, 2003 Mazda Protege5, 2003 Mazda Protege, 2003 Mazda MX-5 Miata, and 2003 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When installing NEW Crankshaft Position (CKP) sensor, sensor must be touching damper. CKP sensor has wear tabs that will wear off after several engine revolutions.

NOTE: Numbers in parenthesis refer to numbers in illustration.

Disconnect the Crankshaft Position (CKP) sensor harness connector (1). See Fig 1.
Remove the bolts (2). See Fig 1.
Remove the sensor (3). See Fig 1.
To install, reverse the removal procedures. See TORQUE SPECIFICATIONS .

Fig 1: Removing & Installing CKP Sensor - B4000

Courtesy of MAZDA MOTORS CORP.