Removal & Installation (Miata)
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2003 Mazda Tribute, 2003 Mazda Protege5, 2003 Mazda Protege, 2003 Mazda MX-5 Miata, and 2003 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Make sure that the CMP sensor is free of any metallic shavings or particles. If metallic shavings or particles are found on the sensor, clean them off.
- Disconnect the negative battery cable.
- Disconnect the Camshaft (CMP) sensor connector. See Figure.
- Remove the CMP sensor installation bolt.
- Remove the CMP sensor.
- To install, reverse removal procedure. See TORQUE SPECIFICATIONS .