Fuel Pump Relay Inspection - Protege & Protege5
WARNING: This page is about a different car, the 2003 Mazda Protege5, 2003 Mazda Protege, 2003 Mazda MX-5 Miata, 2003 Mazda MPV, and 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
Remove fuel pump relay. See FUEL PUMP RELAY LOCATIONS table. Using ohmmeter, check for continuity between relay terminals "C" and "E". See Fig 1. Continuity should not be present. Using fused jumper wires, connect positive battery terminal to fuel pump relay terminal "A". Connect negative battery terminal to fuel pump relay terminal "B". Continuity should be present between fuel pump relay terminals "C" and "E". If continuity is not as specified, replace fuel pump relay.
FUEL PUMP RELAY LOCATIONS
| Application | Location |
|---|---|
| MAZDA6 | Behind Left Kick Panel In Fuse/Relay Box. |
| Miata | Under Left Side Of Dash, Above Left Kick Panel |
| MPV, Protege & Protege5 | Fuse/Relay Box On Left Side Of Engine Compartment |