LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Engine Controls [System & Component Testing]) >> Engine Sensors & Switches >> Throttle Position Sensor >> Resistance Inspection (Miata)

Resistance Inspection (Miata)

WARNING: This page is about a different car, the 2003 Mazda Protege5, 2003 Mazda Protege, 2003 Mazda MX-5 Miata, 2003 Mazda MPV, and 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect TP sensor 3-pin harness connector. See Figure. Using DVOM, measure resistance between following TP sensor terminals:
    • Terminals "A" and "B" - 2500-5000 ohms.
    • Terminals "B" and "C" - 200-1100 ohms.

    If resistance readings are not as specified, replace TP sensor.

scientia non olet · About LEMON Manuals