Detection Condition
WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
If PCM detects TP sensor No. 1 voltage at PCM 104-pin harness connector terminal No. 89 is 4.72 volts or more after ignition is on, PCM determines TP circuit has a malfunction. This is a Continuous Monitor (CM). MIL illuminates if PCM detects malfunction condition during first drive cycle. PENDING CODE is available if PCM detects malfunction condition. FREEZE FRAME DATA is available. DTC is stored in PCM memory.