LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Engine Controls [Self-Diagnostics 2.3L]) >> Diagnostic Tests >> DTC P0038: Rear Ho2S Heater Circuit - High Input >> Detection Condition

Detection Condition

WARNING: This page is about a different car, the 2003 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

PCM monitors rear HO2S heater control signal at PCM 30-pin harness connector terminal "4D" (White/Green wire). If PCM turns rear HO2S heater on but rear HO2S heater circuit has high voltage, PCM determines that rear HO2S heater circuit has malfunction. This is a continuous monitor (O2 sensor heater). MIL illuminates if PCM detects malfunction condition in two consecutive drive cycles or in one drive cycle while DTC for same malfunction has been stored in PCM. PENDING CODE is available if PCM detects malfunction condition during first drive cycle. FREEZE FRAME DATA is available. DTC is stored in PCM memory.

scientia non olet · About LEMON Manuals