LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Engine Controls - Adjustments - 2.3L) >> Throttle Position (TP) Sensor >> Throttle Position (TP) Sensor Continuity >> Inspection

Throttle Position (TP) Sensor Continuity: Inspection

WARNING: This page is about a different car, the 1997 Mazda Millenia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition off. Ensure throttle valve is in closed position. Disconnect TP sensor connector. Check for continuity between terminals "C" and "D" of TP sensor connector. Continuity should exist. If continuity exists, go to next step. If continuity does not exist, adjust TP sensor.
  2. Insert a feeler gauge of specified thickness between throttle lever and throttle stop screw. See TP SENSOR CONTINUITY table. Connect ohmmeter between terminals "C" and "D" of TP sensor connector. If continuity is not as specified, adjust TP sensor.
scientia non olet · About LEMON Manuals