Rear Antenna Feeder Inspection

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.

Remove the console. (See CONSOLE REMOVAL/INSTALLATION .)
Disconnect the connection between the front antenna feeder and the rear antenna feeder.
Remove the trunk side trim (LH). (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
Disconnect the connection between the rear antenna feeder and the power antenna. (With manual antenna)
Verify that there is no continuity between rear antenna feeder terminals A and B using an ohmmeter.

Fig 1: Identifying Rear Antenna Feeder
Courtesy of MAZDA MOTORS CORP.
Inspect for continuity between the rear antenna feeder terminals using an ohmmeter.
- If not as specified, replace the rear antenna feeder.
Fig 2: Rear Antenna Feeder Terminal Connector Continuity
Courtesy of MAZDA MOTORS CORP.