LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 538 (Lighting System) >> Front Fog Light Adjustment [Except BP With TC]

Front Fog Light Adjustment [Except BP With TC]

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust the tire air pressure to the specification.
  2. Position the unloaded vehicle on a flat, level surface.
  3. Seat one person in the driver's seat.
  4. Position the vehicle straight ahead and perpendicularly to a wall.
  5. Set the front fog light 3 m {10 ft}  from the white screen.
  6. While adjusting one front fog light, disconnect the connector of the other.
  7. Start the engine to charge the battery.
  8. Turn over the mud guard.
    Fig 1: Setting Front Fog Light 3m From White Screen
    G03638921Courtesy of MAZDA MOTORS CORP.
  9. Adjust the front fog light by turning the adjusting screws as shown in the figure. Loosen the screws first, then tighten them.
    NOTE:
    • If the adjusting screws are tightened first, then loosened, they will continue to loosen when the vehicle is in motion and may cause the front fog light to become misaligned.
    Fig 2: Adjusting Front Fog Light By Turning Adjusting Screws
    G03638922Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals