Detachable Hardtop

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The rear window molding is a replacement part.

Remove the rear window molding.
Apply protective tape along the edge of the body to protect it from damage.
Remove the rear window glass installation nuts.
Make a hole through the sealant and the dam from the inside of the vehicle using an awl.
WARNING:
- Using a SST (piano wire) with bare hands can cause injury. Always wear gloves when using a SST (piano wire).
Pass the SST (piano wire) through the hole.
Wind each end of the SST (piano wire) around a bar.
NOTE:
- Use the entire length of SST (piano wire) to prevent it from breaking when cutting through the sealant.
Fig 1: Inserting Piano Wire
Courtesy of MAZDA MOTORS CORP.
Working with another person, saw through the sealant around the edge of the glass, being careful not to damage the body.
WARNING:
- Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
Fig 2: Sawing Through Sealant
Courtesy of MAZDA MOTORS CORP.
Use a razor to cut the places of rear window glass installation nuts where the SST (piano wire) will not cut.

Fig 3: Identifying Places Of Rear Window Glass Where Wire Will Not Cut
Courtesy of MAZDA MOTORS CORP.
Remove the rear window glass.
Remove the dam.

Fig 4: Removing Rear Window Glass And Dam
Courtesy of MAZDA MOTORS CORP.