Seat Belt Inspection: ELR

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

If the load limiter mechanism operates, the belt will no longer withdraw and retract normally. Replace the belt if the load limiter mechanism operates.

Verify that the belt can be pulled out smoothly, and that it moves smoothly when wound.
Verify that the retractor locks when the belt is quickly pulled.
Remove the retractor. (See SEAT BELT REMOVAL/INSTALLATION .)
Hold the retractor as it would be installed.
Slowly incline the retractor while pulling out the belt.
Verify that the retractor locks at approximately 30° inclination.
- If not as specified, replace the seat belt.
Fig 1: Identifying Belt Tensioner
Courtesy of MAZDA MOTORS CORP.

Fig 2: Locking Retractor At 30° Inclination
Courtesy of MAZDA MOTORS CORP.