Refrigerant Lines Removal Note

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

There are two types of SSTs:
49 N061 001 (high-pressure) and 49 N061 002 (low-pressure).

Set the SST into the clamp with the arrow mark on the clamp facing the SST .

Fig 1: Setting SST Into Clamp
Courtesy of MAZDA MOTORS CORP.
Push the SST with your thumb until the clamp clicks.
CAUTION:
- If the SST is pushed with excessive force, the clamp will deform. Be careful when pushing the SST into the clamp.
Fig 2: Pushing SST With Your Thumb
Courtesy of MAZDA MOTORS CORP.
Pull up the stopper, then pull the SST from the pipe.
Remove the SST from the clamp.
CAUTION:
- Be careful not to bend the SST needles when performing a clamp removal. If the needles are bent, the clamp can not be unlocked.
Fig 3: Removing SST
Courtesy of MAZDA MOTORS CORP.