LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 523 (Automatic Transmission [Shift Mechanism]) >> Shift-Lock Actuator Removal/Installation

Shift-Lock Actuator Removal/Installation

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the rear console.
  3. Remove the indicator screws and lift up the indicator panel.
  4. Disconnect the shift-lock actuator connector.
  5. Disconnect the P position switch connector.
  6. Remove the shift-lock actuator.
  7. Install a shift-lock actuator.

    Tightening torque 

    0.7-1.2 N.m {8-12 kgf.cm, 6.2-10.6 in.lbf} 

  8. Connect the P position switch connector.
  9. Connect the shift-lock actuator connector.
  10. Adjust the indicator panel. Install the screws in the order shown in Fig 1.

    Tightening torque 

    1.5-2.4 N.m {16-24 kgf.cm, 14-21 in.lbf} 

    Fig 1: Installing Shift-Lock Actuator Screws
    G03638457Courtesy of MAZDA MOTORS CORP.
  11. Install the rear console.
  12. Verify correct operation of the shift-lock system.
  13. Connect the negative battery cable.
scientia non olet · About LEMON Manuals