Indicator Panel Adjustment
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Shift the selector lever to the P position.
- Loosen the indicator screws.
- Align the alignment hole in the slider with the hole in the indicator panel. Install suitable heavy-gauge wire to hole the slider.
- Tighten the indicator mounting screws in the order shown in Fig 1.
Tightening torque
1.5-2.4 N.m {16-24 kgf.cm, 14-21 in.lbf}
- Remove the wire from the slider.
- Verify that the selector lever properly aligns with the indicator in each range.
- Verify correct operation of the emergency override button.