Transmission Range (Tr) Switch Adjustment
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Remove the selector rod from the manual shaft lever.
- Rotate the manual shaft to the N position.
- Loosen the TR switch mounting bolt.
- Align the cut groove in the switch with the neutral reference line.
- Tighten the TR switch mounting bolt.
Tightening torque
- 4.0-6.8 N.m {40-70 kgf.cm, 35-60 in.lbf}
- Install the selector rod to the manual shaft lever.
- Connect the negative battery cable.
- Inspect the operation of the TR switch. (See TRANSMISSION RANGE (TR) SWITCH INSPECTION .)