LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 522 (Automatic Transmission [Service, Removal & Installation]) >> Output Speed Sensor Removal/Installation

Output Speed Sensor Removal/Installation

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Disconnect the output speed sensor connector.
  3. Remove the output speed sensor from the transmission
  4. Apply ATF to a new O-ring.
  5. Install the O-ring to the output speed sensor.
  6. Install the output speed sensor to the transmission.

    Tightening torque 

    5.0-6.8 N.m {50-70 kgf.cm, 44-60 in.lbf} 

  7. Connect the output speed sensor connector.
  8. Connect the negative battery cable.
scientia non olet · About LEMON Manuals