LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 522 (Automatic Transmission [Service, Removal & Installation]) >> Input/Turbine Speed Sensor Removal/Installation

Input/Turbine Speed Sensor Removal/Installation

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the bracket and front pipe. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [BP] .)
  3. Disconnect the input/turbine speed sensor connector.
  4. Remove the input/turbine speed sensor.
  5. Remove the O-ring from the input/turbine speed sensor.
  6. Apply ATF to a new O-ring.
  7. Install the O-ring to the input/turbine speed sensor.
  8. Install the input/turbine speed sensor.

    Tightening torque 

    1. 5.8-8.8 N.m {59-90 kgf.cm, 52-78 in.lbf} 
  9. Connect the input/turbine speed sensor connector.
  10. Install the front pipe and bracket. (See EXHAUST SYSTEM REMOVAL/INSTALLATION [BP] .)
  11. Connect the negative battery cable.
scientia non olet · About LEMON Manuals