LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 521 (Manual Transmission [Service, Removal & Installation M15M-D)) >> Vehicle Speedometer Sensor Removal/Installation

Vehicle Speedometer Sensor Removal/Installation

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Drain the transmission oil. (See TRANSMISSION OIL REPLACEMENT .)
  3. Disconnect the vehicle speedometer sensor connector.
  4. Remove the vehicle speedometer sensor.
  5. Apply transmission oil to a new O-ring and install it on a new vehicle speedometer sensor.
  6. Install the vehicle speedometer sensor.

    Tightening torque 

    7.9-10.7 N.m {80-110 kgf.cm, 69.5-95.4 in.lbf} 

  7. Connect the vehicle speedometer sensor connector.
  8. Add the specified amount and type of transmission oil. (See TRANSMISSION OIL REPLACEMENT .)
  9. Connect the negative battery cable.