Boot Band (Axle Side) Assembly Note

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.

Turn the adjusting bolt of the SST and adjust the opening size to the specification A.
Specification A
1. 2.9 mm {0.11 in}
Fig 1: Adjusting Bolt Of SST
Courtesy of MAZDA MOTORS CORP.
Crimp the boot band (small-size) using the SST .
Verify that the crimp value B is within the specification.
- If the crimp value B exceeds the specification, reduce opening length A of the SST and recrimp the boot band.
- If the crimp value B is less than the specification, increase opening length A of the SST and crimp the new boot band.
Specification B
1. 2.4-2.8 mm {0.095-0.110 in}
Fig 2: Crimping Boot Band
Courtesy of MAZDA MOTORS CORP.
Verify that the boot band does not protrude from the boot band installation area.
- If the boot band protrudes from the installation area, replace it with a new band and repeat Step 2 -- 4.
Fill the boot with the repair kit grease.
Adjust opening length A of the SST to the specification.
Specification A
1. 3.2 mm {0.13 in}
Crimp the boot band (large-size) using the SST .
Verify that the boot band crimp value B is within the specification.
- If crimp value B exceeds the specification, reduce opening length A of the SST and recrimp the boot band.
- If the crimp value B is less than the specification, replace the boot band, increase opening length A of the SST , and then recrimp the new boot band.
Specification B
1. 2.4-2.8 mm {0.095-0.110 in}
Verify that the boot band does not protrude from the boot band installation area.
- If the boot band protrudes from the installation area, replace it with a new band and repeat Step 7-- 9.