LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Drive Shaft) >> Drive Shaft Disassembly/Assembly (BP With TC) >> Boot Assembly Note

Boot Assembly Note

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • The boot shapes on the axle side and the differential side are different so do not misinstall them.
  1. Fill the inside of the new dust boot (wheel side) with grease.
    NOTE:
    • Do not touch the grease with your hand. Apply it from the tube to prevent foreign matter from entering the boot.

    Grease amount 

    1. 70-90 g {2.47-3.17 oz} 
  2. Install the boot with the drive shaft spline still wrapped with vinyl tape.
  3. Remove the vinyl tape.
scientia non olet · About LEMON Manuals