LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Engine Controls - Tests W/Codes - 2.3L) >> Circuit Tests >> DTC P1170 - Right Front Oxygen Sensor, Activity Not Detected >> Diagnosis & Repair Procedure

Diagnosis & Repair Procedure

WARNING: This page is about a different car, the 1997 Mazda Millenia. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect all applicable harness connectors. Repair as needed. Turn ignition on. Access ECM harness connector. ECM is mounted in front of center console, under radio. Using voltmeter, backprobe applicable ECM harness connector. Measure voltage between ground and terminal No. 3I.
  2. Voltage should be 0-1.0 volt with engine idling at normal operating temperature. If voltage is within specification, go to step 5). If voltage is not within specification, go to next step.
  3. Turn ignition off. Disconnect right front oxygen sensor harness connector. Using ohmmeter, backprobe ECM harness connector. Check continuity between terminal "A" on right front oxygen sensor harness connector and terminal No. 3I on ECM connector. If continuity does not exist, repair Red wire. If continuity exists, go to next step.
  4. Inspect fuel injectors, mass airflow sensor, engine coolant temperature sensor. See appropriate SYSTEM/COMPONENT TESTS - 2.3L article. Replace as needed. Inspect fuel pressure regulator. See appropriate BASIC TESTING - 2.3L article. Replace as needed. Inspect spark plugs and air intake system. Repair or replace as needed. If all items are okay, replace right front heated oxygen sensor.
  5. Erase DTCs. See CLEARING CODES  in SELF-DIAGNOSTIC SYSTEM section. If DTC resets, replace ECM. If DTC is not present, intermittent poor harness connection may have caused DTC to originally set.
scientia non olet · About LEMON Manuals