Continuity Inspection

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Perform the following test only when directed.

Disconnect the negative battery cable.
Remove the service hole cover.
Disconnect the FP connector.
Inspect for continuity between FP connector terminals B and D.
- If there is no continuity, replace the FP body.
- If as specified, carry out the "Circuit Open/Short Inspection".
Fig 1: Inspecting Continuity Between FP Connector Terminals
Courtesy of MAZDA MOTORS CORP.