LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 494 (Engine Mechanical (Service Information)) >> Timing Belt Removal/Installation >> Cylinder Head Cover Installation Note

Cylinder Head Cover Installation Note

WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply liquid gasket to the portions shown in Fig 1.
    Fig 1: Applying Liquid Gasket
    G03637680Courtesy of MAZDA MOTORS CORP.
  2. Temporarily tighten the cylinder head cover bolt on the portion A shown in Fig 2.
    CAUTION:
    • Do not damage the O-ring while installing the OCV case. If the O-ring of the OCV adapter on camshaft cap is damaged, it may cause hydraulic leakage.
    Fig 2: Tightening Cylinder Head Cover Bolt On Portion Of Cylinder Head
    G03637681Courtesy of MAZDA MOTORS CORP.
  3. Tighten the cylinder head cover bolts for several times in the numerical order shown in Fig 3.
    Fig 3: Tightening Sequence Of Cylinder Head Cover Bolts
    G03637682Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals