No.11 Engine Stalls/Quits, Engine Runs Rough, Misses, Buck/Jerk, Hesitation/Stumble, Surges: Notes
WARNING: This page is about a different car, the 2005 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
NO.11 ENGINE STALLS/QUITS, ENGINE RUNS ROUGH, MISSES, BUCK/JERK, HESITATION/STUMBLE, SURGES [BP, BP WITH TC] DESCRIPTION & POSSIBLE CAUSE
| 11 |
Engine stalls/quits-acceleration/cruise Engine runs rough-acceleration/cruise Misses-acceleration/cruise Buck/jerk-acceleration/cruise/deceleration Hesitation/stumble-acceleration Surges-acceleration/cruise |
| DESCRIPTION |
- Engine stops unexpectedly at beginning of acceleration or during acceleration
- Engine stops unexpectedly while cruising
- Engine speed fluctuates during acceleration or cruising
- Engine misses during acceleration or cruising
- Vehicle bucks/jerks during acceleration, cruising or deceleration.
- Momentary pause at beginning of acceleration or during acceleration
- Momentary minor irregularity in engine output
|
| POSSIBLE CAUSE |
- A/C system improper operation
- Erratic signal or no signal from CMP sensor
- Air leakage from intake-air system parts
- Purge solenoid valve malfunction
- Improper operation of IAC valve
- EGR valve malfunction
- Erratic signal from CKP sensor
- Low engine compression
- Vacuum leakage
- Poor fuel quality
- Spark leakage from high-tension leads
- ACL restriction
- PCV valve malfunction
- Improper valve timing due to jumping out of timing belt
- Restriction in exhaust system
- Intermittent open or short in FP circuit
- Inadequate fuel pressure
- FP mechanical malfunction
- Fuel leakage from fuel injector
- Fuel injector clogged
- Intermittent open or short of MAF sensor, TP sensor and VSS
- Automatic transmission malfunction (AT)
- Clutch slippage
- Improper VTCS operation
WARNING:
- The following troubleshooting flow chart contains the fuel system diagnosis and repair procedures. Read the following warnings before performing the fuel system services:
CAUTION:
- Disconnecting/connecting quick release connector without cleaning it may possibly cause damage to fuel pipe and quick release connector. Always clean quick release connector joint area before disconnecting/connecting, and make sure that it is free of foreign material.
|